1/12/2024 0 Comments Isometric drawing piping![]() ![]() With the 'Isometric to Standard' type transposition the result can often be visualized as an offset view from overhead, where the vertical lines can still be seen. This is to avoid any confusion caused by nodes being placed over the top of other nodes or pipes. When clicking the ISO Mode On/Off Toggle button to transpose from isometric view to a 'flattened' standard view, any vertical lines from the isometric view will be drawn at 45 degrees. A rolling offset refers to a directional change (both vertically and horizontally) a pipe can make in a piping system. Selecting either of these options will change the display of all tanks and end pressure on the isometric view. The drawing menu provides options to display an ‘Isometric tank view from the left’ or to display an ‘Isometric tank view from the right’. Tanks and end-pressure nodes will also be displayed in the isometric plane. ![]() When the isometric drawing mode has been selected Pipe Flow Expert will show fittings, valves, components, control valves and pumps in the isometric plane which follows the associated pipe direction. Users can easily switch between these using the ISO Mode On/Off Toggle button. Pipe Flow Expert has two drawing modes, standard (‘flattened’) view and isometric view. Piping Isometric Drawing Piping Plan Drawings/General Arrangement Drawings (GAD) The piping plan or general arrangement drawings (Fig. Isometric drawings are, by definition, a visual depiction of a 3D routed line in a 2D plane that combines pipe height and length in a single drawing with a 30 angle on either side of the horizontal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |